3 Plug the microphone cable into the MIC IN connector, then set the AUDIO IN switch for the channel on which you want to record the audio from this microphone to FRONT (for CH-1/ CH-2) or F (for CH-3/CH-4).

4 Secure the microphone cable with the cable clamps.

Connecting microphones to the AUDIO IN connectors

You can connect up to two monaural microphones to the AUDIO IN CH-1/CH-2 connectors, using a CAC-12 Microphone Holder (not supplied).

The following is the procedure for attaching an electret condenser microphone such as the ECM- 674/678.

On how to attach the CAC-12, refer to the operation manual for the CAC-12.

1 Attach the electret condenser microphone.

1Loosen the ball joint lock lever.

2Place the microphone in the holder so that “UP” is at the top.

3Close the microphone holder.

4 Tighten the screw.

5 Position so that the microphone does not interfere with the viewfinder and tighten the ball joint lock lever.

When attaching the ECM-674/678, use the microphone adaptor supplied with the CAC- 12 Microphone Holder.

 

2 Chapter

Microphone

Preparations

 

2 Connect the microphone cable to the AUDIO IN CH-1 or CH-2 connector.

3 Set the switches as follows.

Set the LINE/AES/EBU/MIC switch to MIC.

•Set the +48V/OFF switch as indicated below, depending on the power supply type of the microphone.

Internal power supply: Set the +48V/OFF switch to OFF.

External power supply: Set the +48V/ OFF switch to +48V (ON).

•Set the AUDIO IN (CH-1/CH-2/CH-3/CH- 4) switch for the channel to which the microphone is connected to REAR (for CH-1/CH-2) or R (for CH-3/CH-4).

Preparing the Audio Input System 45