AUTO INTERVAL **M**S
MANU INTERVAL
The unit is operating in Auto Interval Rec mode (**M**S: Indicates the shooting interval in minutes and seconds).
The unit is operating in the single- shot mode of Manual Interval Rec
Disc Damage A disc that cannot be recorded was inserted. To record, exchange the disc.
Non AV Full The disc is full. Exchange or MAX # Files format the disc.
Over DUR!
9 Chapter
*FRAME
INTERVAL **S (M/H)
*FRAME
mode (*FRAME: Indicates the number of frames recorded in one shot).
The unit is operating in the consecutive mode of Manual Interval Rec mode (**S (M/H): Indicates the trigger interval, in seconds (minutes or hours),
DI read err Read err DRV ADJ err
Run Salvage
The disc was not recognized. Try ejecting the disc and inserting it again. Or exchange the disc.
A disc that requires salvage was inserted. To record on the disc, eject the disc, insert it again, and execute salvage processing.
Maintenance
*FRAME: Indicates the number of frames recorded in one shot).
Salvage NG! Salvage processing failed.
For details, see “Handling of discs when recording does not end
LOW LIGHT
Depending on the setting, the subject illumination is inadequate.
DCP EEPROM DATA NG! DR EEPROM DATA NG! DCP/DR EEPROM DATA NG!
The backup battery of the internal clock is empty. a)
If this message continues to appear even after the unit is powered off and on again several times, then the factory adjustment data is invalid. Contact a Sony service representative.
Salvage
XXXX
REC INHI.!
The loaded disc cannot be salvaged by this unit. The “XXXX” in the message is a code for XDCAM devices that can salvage the disc. Refer to the list of device codes (see page 75) and salvage the disc using one of the indicated devices.
The Write Inhibit tab of the disc is in the recording disabled position, or salvage processing needs to be done on the loaded disc. Set the
a)Contact a Sony service representative to replace the battery.
VDR operation messages are displayed in the setting change and adjustment progress message display area of the viewfinder screen (see page 34). Take the actions listed in the following table.
ILL. Disc! A disc that cannot be used by this unit was inserted. Insert another Professional Disc.
1080/50i
1080/25P
1080/59.94i
1080/29.97P
720/50P
720/59.94P
625/50i
tab to the recording enabled position. Or eject the disc, insert it again, and perform salvage processing.
The loaded disc has a different resolution or a different system frequency. To carry out recording operations, exchange the disc, or change the resolution or system frequency.
ILL. Index!
No FS!
Unknown FS!
No Support!
Index file or file system error. Exchange or format the disc.
A recorded clip cannot be handled by this unit. Exchange or format the disc.
525/59.94i
FORMAT The disc could not be formatted
NG! automatically. Exchange the disc.
Operation Warnings
219