Overview 1 Chapter
|
| 1 |
qf |
| 2 |
|
| |
qg |
| 3 |
|
| |
|
| 4 |
|
| 5 |
|
| 6 |
|
| 7 |
|
| 8 |
|
| 9 |
PEAKING | CONTRAST BRIGHT | 0 |
|
| |
DISPLAY | ZEBRA TALLY | qa |
ON | HIGH | |
OFF | OFF | |
MOMENT | LOW | |
ASPECT |
|
qs qd
aPlug
Connect to the VF connector on the camcorder.
bStopper
Prevents the viewfinder from coming off the camcorder when it is slid from side to side.
cCamera operator tally indicator
Lights up while camcorder is recording. This indicator can be covered when not in use.
This indicator also flashes to indicate warnings, in the same manner as the tally indicator and the REC indicator in the viewfinder.
dEyecup
eIndicators and status display
For details, see “Status display on the viewfinder screen” on page 31.
fDiopter adjustment ring
Allows for optimal focus adjustment.
gTally indicator
Lights up while camcorder is recording. Set the TALLY switch to OFF when not in use. The brightness can also be adjusted with the TALLY switch.
This indicator also flashes to indicate warnings, in the same manner as the camera operator tally indicator and the REC indicator in the viewfinder.
hPEAKING control
Turning this control clockwise adjusts the picture sharpness, and makes focusing easier. This control has no effect on the output signals of the camcorder.
iCONTRAST control
Adjusts the contrast of the screen. This control has no effect on the output signals of the camcorder.
jBRIGHT control
Adjusts the brightness of the screen. This control has no effect on the output signals of the camcorder.
kTALLY switch
Controls the tally indicator located on the front of the viewfinder.
HIGH: The tally indicator brightness is set to high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
lZEBRA (zebra pattern) switch
Controls the zebra pattern display on the viewfinder screen as follows.
ON: A zebra pattern appears and stays.
OFF: The zebra pattern disappears.
MOMENT: A zebra pattern appears and stays for about five seconds.
mDISPLAY/ASPECT switch
Turns the marker indication on and off, and switches between 4:3 and 16:9 aspect ratios for viewfinder screen display.
DISPLAY: When the marker indication is enabled with the camcorder, the marker indication on the viewfinder screen turns on and off every time you push the switch up to this position.
ASPECT: Each push of the switch down to this position toggles the mask display on and off. (Make mask display settings on the MARKER 1 page of the OPERATION menu (see page 132).)
30Locations and Functions of Parts and Controls