SLAVE
Press the “MENU” + ADVANCE SETUP + “ENTER” + INPUT OUTPUT + “ENTER”
+INTERNAL GPS SETUP + “ENTER” + OPERATING MODE + “ENTER”+ SLAVE
+“ENTER”
TRANSFERING USER POINTS:
STANDARD HORIZON Chart Plotters can transfer User Points between plotters:
User Point List Send/Receive
To use this function the Blue wire of the Master must be connected to the Brown wire of the Slave.
Sending User Points from Master to Slave:
1.On the Slave: Press “MENU” + USER POINTS LIST + “ENTER”+ RECEIVE + “ENTER” . This enables the receive mode on the Slave. The Slave will listen 2 minutes for the user points to be sent from the Master.
2.On the Master: Press “MENU” + USER POINTS LIST + “ENTER”+ SEND + “ENTER”.
Sending User points from Slave to Master:
1.On the Master: Press “MENU” + USER POINTS LIST + “ENTER”+ RECEIVE + “ENTER”. This enables the receive mode on the Slave. The Slave will listen 2 minutes for the user points to be sent from the Master.
2.On the Slave: Press “MENU” + USER POINTS LIST + “ENTER” + SEND +
“ENTER” .
NOTE
When sending or receiving user points the autopilot NMEA output and the receiving of GPS Satellite signal is disabled.
3.15TERMS AND FUNCTIONS 3.15.0User Points Handling functions
User Points are
Example of typical User Point shapes:
Figure 3.15.0 - User Points icons
User Point colors is to be chosen amongst the colors not already used to fill the charts (Depth areas, Attention area, in order to make User Points better visible when placed on the charts).
Page 52 |
| GPS Chart 150C |
|
