TANDBERG D5016402 user manual Powering on the System, System Setup

TANDBERG Director Videoconferencing System Installation

Powering on the System

Once the system is installed in the appropriate location, it is now ready for the AC mains to be plugged in. To verify that all components have been powered on, you should be able to see the following LED indicators through the smoked glass cover of the Director Application Module.

YELLOW

If any of the green or red LED’s do not show through the smoked glass, the system will not work properly. Contact TANDBERG Technical Service immediately.

To power on the projector, press the green PROJECTOR STANDBY button on the front of the 3000i cabinet. Once powered, refer to ‘SYSTEM SETUP’ for screen calibration.

GREENRED

N O T E IT IS RECOMMENDED THAT YOU PRESS THE

GREEN PROJECTOR STANDBY BUTTON TO

PLACE THE SYSTEM IN STANDBY WHENEVER IT IS NOT IN USE. THIS WILL MAXIMIZE THE LIFE OF LAMP INSIDE THE PROJECTOR.

System Setup

SMART BoardTM Projector Setup and Calibration

When you press the POWER BUTTON on the 3000i front control panel unit to activate the projector display, it will then require approximately 40 seconds to complete the start-up routine, at which point the TANDBERG start-up screen will be displayed.

For SMART BoardTM software installation and configuration, or any additional information, please reference the ‘REAR PROJECTION SMART BOARDTM 3000i INSTALLATION GUIDE’.

21