TANDBERG Director Videoconferencing System

Advanced Use

 

 

External network settings

NOTE

THE PHYSICAL INTERFACE ON

EXTERNAL NETWORKS IS ONE NON-

STANDARD 26 PIN CONNECTOR.

SPECIAL CABLES ARE REQUIRED.

Before using the system together with external network equipment, you must specify the network parameters on this page.

N O T E

THE SYSTEM HAS SUPPORT FOR

UP TO 768KBPS/2MBPS USING

THE EXTERNAL NETWORK

(RS449/V.35/X.21) INTERFACE.

Call control

‘RS366 Dialing’ is the only dialing protocol and would normally be used together with network clocking ‘RS449/V35 Compatible’ when the external equipment uses RS366 ports.

‘Leased Line’ is a non-dialing protocol and should be used when two codecs are connected in a point to point connection. Use ‘Leased Line’ when the handshaking signals DTR and CD are available. DTR and CD correspond to the X.21 network’s C and I signals.

‘Data Triggered’ mode uses TxData (transmit data), RxData (receive data) and clock signals only. Use ‘Data Triggered’ when no handshake signals are available.

‘Manual’ should be used when no handshake signals are available, and the external equipment requires a constantly connected line.

T I P

TO MAKE AN IP CALL WHEN ‘LEASED LINEIS SELECTED, ENTER A NUMBER BEFORE PRESSING CONNECT TO ACTIVATE THE DIAL MENU.

79

Page 79
Image 79
TANDBERG D5016402 user manual External network settings, Call control