TANDBERG D5016402 user manual IP Settings

Advanced Use TANDBERG Director Videoconferencing System

IP Settings

N O T E

CHANGES IN THIS MENU WILL NOT HAVE ANY EFFECT BEFORE THE SYSTEM IS RESTARTED.

IP-assignment

DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is present.

DHCP IP-address, IP-subnet mask and Gateway are not used because these parameters are assigned by the DHCP server.

STATIC The codec’s IP-address and IP-subnet mask must be specified in the IP-address field.

IP-address

IP-address defines the network address of the codec. This address is only used in static mode. In DHCP-mode, the assigned IP-address can be found on the Welcome Menu.

IP-subnet mask

IP-subnet mask defines the type of network. This address is only used in static mode. Your LAN- administrator will provide the correct value for this field.

Gateway

When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP addresses, IP address, subnet mask, and default gateway must be specified by the LAN administrator.

Ethernet Speed

AUTO The codec will auto-detect the speed/duplex on the LAN.

10/HALF The codec will connect to the LAN using 10Mbps speed/Half Duplex.

10/FULL 10 Mbps speed/Full Duplex. 100/HALF 100 Mbps speed/Half Duplex. 100/FULL 100 Mbps speed/Full Duplex.

Restart

Pressing the QUICK KEY ‘Restart’ will restart your system without having to use the On/Off switch on the codec. If IP-assignment is changed, it is sufficient to use this QUICK KEY to restart the system.

86