TANDBERG Director Videoconferencing System
Manual Dialing
To manually dial a number:
1. In the ADDRESS BOOK select the MANUAL DIAL button.
2.Enter the number of the desired site using the KEYPAD. Press DELETE to remove the last character or CLEAR to start again.
3.Press SELECT QUALITY to change the call bandwidth from the default. Use the UP/DOWN ARROWS to scroll through the available call bandwidths.
4.Press the green CONNECT button. The call will be established as defined.
5.If the remote site is not answering select the red HANG UP button to disconnect the call.
6.When the call is established the Videoconference Main Screen will be displayed.
On the Manual Dial screen the following controls are also available:
REDIAL | will attempt to call the last manually dialed number. |
CALL STATUS | will display information on the currently connected calls. Press the |
| BACK button to exit from this screen. |
DIRECTORY | will bring you back to the Address Book screen. |
Disconnecting a Call
An active videoconference call can be disconnected at any time.
1.On the TASKBAR select CALL CONTROL to access the Call Control screen.
2.Select the red HANG UP button.
3.You will be asked to confirm: ‘Yes, Hang up.’
46
