TANDBERG D5016402 user manual Audio Outputs, Level Settings Outputs

TANDBERG Director Videoconferencing System Advanced Use

Audio Outputs

Out1 is intended for connection to TANDBERG Natural Audio, televisions or audio amplifiers.

Out2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The signal is a mix of audio from both the far end and local end (not from Audio in 5).

Out3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio from far end and local end (not from Audio in 6).

Audio Module: Select Natural Audio Module (NAM or NAM II) according to the type of Audio Module installed.

If an output is ‘Off’, no audio will be sent to that output.

N O T E

NEVER CONNECT AUDIO OUT 2 OR AUDIO OUT 3 TO A LOUDSPEAKER PLACED IN THE SAME ROOM AS THE MICROPHONES CONNECTED TO THE SYSTEM. DOING THIS WILL CAUSE “HOWLING” AND POSSIBLE DAMAGE TO THE SPEAKER SYSTEM.

Level Settings - Outputs

Adjust the audio output levels according to the parameters of the external audio equipment connected. These levels should only be adjusted when installing new audio equipment. The default settings are correct for most consumer electronics devices (televisions, VCRs, etc.).

The volume buttons on the IR control adjust the level of output 1 (the speaker output). The volume control has no effect on outputs 2 and 3.

65