Taylor C118, C116, C117 manuel dutilisation Trouble-Shooting, Possible Causes, English, Remedies

7.2 TROUBLE-SHOOTING

TROUBLE	POSSIBLE CAUSES	REMEDIES
The machine does not start (STOP	Electric trouble.	Send for a technician.
pushbutton ON without active
	Incorrect power supply.	Check phases.
alarms)
The machine does not start	Master switch open.	Turn the the switch off.
(pushbuttonSTOP off)	Burnt fuses.	Check and replace.
		Check for the presence of water in
	Machine with water condensating	the water system to which the
Since the first phases of the batch	system: lack of condensing water.	machine is connected. Check the
freezing cycle, the compressor		cocks.
works intermittently	Machine with air condensating	Clean the condenser by means of
	system: dirty air condenser or	a brush and check that the fan
	broken down fan.	motor correctly works.
		Check condensating.
The machine interrupts the batch	Alarm: safety timer: the maximum
		Make sure that the room
freezing cycle after 16’ and	time set for batch freezing has	temperature is not too high.
switches to STOP mode	been exceeded.	Make sure that you have used a
		correct amount of mixture and that
		it is properly balanced.
The machine interrupts the batch	Alarm: lack of growth in	Make sure that you have used a
freezing cycle after 16’ and
	consistency: the consistency has
switches to STOP mode, an		correct amount of mixture and that
	not grown within the sampling
intermittent beep is released and		it is properly balanced.
	interval (Step 7 OMEGA)
the agitator keeps working.
	Worn out agitator scraping pads.	Check and replace if required
	Trouble in freezing system.	Send for a technician.
	Unbalanced mixture or wrong	Make sure that you have used a
		correct amount of mixture and that
The machine works regularly but	amount of mixture.
		it is properly balanced.
the ice-cream is too soft.
	Insufficient condensating.	Check condensating and make
		sure that the room temperature is
		not too high.
	In semi-automatic cycle: the	Programme a higher consistency
	programmed consistency value is
		value.
	too low.
During batch freezing the machine	The belts slip.	Check the belt tension and in case
is noisy and the agitator stops.		of necessity replace all the belts.
During the delivery of ice-cream,	The product is too hard.	Make sure that you have pressed
the machine is noisy.		the “DELIVERY”pushbutton.
Traces of liquid ice-cream in the	Worn-out agitator stuffing box.	Check and/or replace.
drip drawer.

ENGLISH - 18