Removal and Installation Procedures
AWG510 & AWG520 Service Manual
3. Remove the handle:
a. Insert the tips of a pair of needle-nose pliers (Item 5) into the hole of
either handle cap. Push and hold to depress the handle release.
b. While holding the handle released, pull it out of the slot in the handle
cap. Repeat procedure to remove the handle from the other handle cap.
c. Reverse procedure to reinstall.
4. Remove the handle caps:
a. Insert the retaining ring pliers (Item 9) into the opening created in the
handle cap when you removed the handle.
b. While using the pliers to expand the handle cap outward, grasp it and
snap it off.
c. Repeat procedure to remove the remaining cap as needed; push the
cap(s) back on to reinstall.
5. Remove the flip stand: Grasp the flip stand by both sides near where it joins
each flip stand foot. Now compress the flip stand until the flip stand ends
clear the flip stand feet to complete the removal.
6. Remove the flip stand foot (or feet):
a. Do Cabinet procedure (page 6–20) to gain access to inside of the
cabinet.
b. Working from inside the cabinet, push the two retainers to release the
flip stand foot you wish to remove and lift it away from the outside of
the cabinet.
c. Repeat procedure to remove as many of the remaining feet as needed;
insert the two retainers back in their slots in the cabinet and snap into
place any flip stand foot removed.
7. Reinstallation: If any flip stand feet were removed, reinstall as directed in
step 6c; then see Cabinet procedure (page 6–20) to reinstall the rear cover
and cabinet. Do in reverse order steps 3 and 5, reversing each step, to
reinstall the flip stand, then the handle caps (if removed), then the handle.