Tektronix AWG520, AWG510 The Numeric Keypad

Operating Information
2-14 AWG510 & AWG520 Service Manual
Figure 2–6 shows the numeric keypad, with descriptions of the button opera-
tions.
    
      
   "  
  
  ! 
  
   
     
  
  
   
Figure 2-6: Keypad buttons
The G, M, k, m, m, n, and p buttons are for entering measurement units.
The A, B, C, D, E, and F buttons are used for entering hexadecimal values.
To use the numeric keypad to enter a value, position the caret to where you want
to change a value and then push a keypad button. If you want to enter a unit
value labeled in blue just above each numeric button, push or hold down the
SHIFT button and then push the corresponding numeric button.
To enter or change more than one character, move the caret to the next position
to change. When you are done entering values, push the ENTER button to
confirm the changes and enter them into the instrument. For example, to enter
200.5 ms, push 2, 0, 0, ., 5,  (SHIFT + 4),and ENTER.
When you enter a value larger than the maximum value in the range for the
parameter, the parameter will be set to the maximum value. As the same fashion,
when you enter a value smaller than the minimum value, the minimum value
will be set in the parameter. To set to the maximum or minimum value, enter a
great larger value or smaller value. This is useful when you do not know the
range that can be set.
The Numeric Keypad