Oven Features | SEM/SEMW Oven Care and Use Manual |
Interpreting the Control Panel: Sights & Sounds
The directions in the Care and Use Manual for setting the oven and its various modes are based on the assumption that the control panel displays and sounds will lead you through the process. To assist you further, the following descriptions will help you interpret what is seen and heard.
Flashing Symbols or Numbers
Signals an incomplete setting; calls for another step or START to be touched.
1 Beep
Signals the receipt of an entry.
2 Short Beeps
Signal an error in entry.
4 Long Beeps
Signal the end of a setting.
Volume
The volume of the beeps can be adjusted. Touch and hold the START pad and the PROBE pad for three seconds. Touch PROBE pad again to increase or decrease volume, from levels 1 to 3. Touch START to set volume selection.
Active Oven Symbol
This symbol indicates which mode is being displayed.
Probe Symbol
Displays the internal temperature of the meat rather than the oven roasting temperature. Oven tem- perature can be seen briefly by touching the cook mode after touching START.
Door Lock Indicator
Displays during the
Err
Displays if an invalid temperature or time is entered.
Power Failure
After the power returns to the oven, the clock dis- plays the time when the power was lost or turned off.
F Number Codes
These codes are displayed when there is a problem with the signal sent to the electronic control board. See Solving Operational Problems, Page 36.
Convection Fan
Operates during any convection mode. The fan turns off if the door is opened. The convection fan will also run during the preheat time.
Component Cooling Fan
Activates during any cooking or
208 VOLT CONNECTION
•Preheat time will be slightly longer.
•Broil time will be slightly longer.
•The
8