Trane SYS-APM001-EN manual System Configurations Chiller sequencing in decoupled systems

System Configurations

Chiller sequencing in decoupled systems

Given the amount and direction of flow in the bypass line, chillers can be added or subtracted.

Adding a chiller

When there is deficit flow in the bypass line, the system is receiving water at a temperature above the desired supply water temperature. At this point in time, a chiller and pump may be added. Many operators sense deficit flow for a particular amount of time (for example, 15 minutes) to ensure that the deficit flow is not a result of some transient condition. This reduces the chances of cycling a chiller; that is, turning on a chiller and then turning it off after a short time.

Subtracting a chiller

A chiller may be turned off when enough surplus water is flowing through the bypass line. How much is enough? Enough so that the chiller does not need to cycle on again in a short time period. Many system operators compare the amount of surplus flow with the flow rate of the chiller they are considering turning off. If this ratio is 110 to 115 percent, they turn the chiller off. Let’s look at an example:

Chiller 1 can make 960 gpm [60.6 L/s] of 40°F [4.4°C] chilled-water, while Chiller 2 can make 1,440 gpm [90.8 L/s]. At present, there is 1,100 gpm [69.4 L/s] of surplus flow in the bypass line.

•The surplus bypass flow is presently 115 percent of Chiller 1’s flow. If we turn Chiller 1 off, we will have 140 gpm [8.8 L/s] of surplus flow left.

•Note that the surplus bypass flow is presently only 76 percent of Chiller 2’s flow. If we turn Chiller 2 off, we will have 340 gpm [21.5 L/s] of deficit flow. It is clear that we would have to cycle that chiller back on soon.

In this case, we could turn Chiller 1 off and leave Chiller 2 on for the most efficient use of the chillers.

Multiple chilled-water plants on a distribution loop

When decoupled systems are used on large campus-type systems, added loads are often located some distance away from the original loads. Yet, planners like the idea of somehow hooking the new loads to the existing system. The double-ended system shown in Figure 36 is one way of handling this requirement. A second production facility is placed at a convenient location in the new part of the campus. Its distribution plant is laid out as a mirror image of the original piping, and connects to it at the ends of each system. Each production facility has its own bypass.

Both production loops feed into the now common distribution loop. Depending on the flows from the production facility distribution pumps, loads could be served by either plant.

52 Chiller System Design and Control SYS-APM001-EN