Installation 2-61
Replacing Processor Card Components
Replacing FLASH Modules
Introduction You can replace a FLASH module on a 6500PLUS processor card. The location of a
FLASH module is shown in Figure2-17.
Caution
Use proper handling and grounding precautions, including the use of an anti-static
grounding strap, whenever you handle a card
Replacement
Procedure
Follow these steps to replace a FLASH module (see Figure2-22):
Step Action
1Remove the card from the nest or enclosure.
You might have to wiggle the card until the header pins disengage
from the socket on the card.
2a)Loosen and remove the four screws that hold the FLASH
module to the processor card.
b) Carefully lift the FLASH module from the 6500PLUS processor
card.
3Using the old module as a guide, insert the header pins of the new
module.
4Place the new module on the 6500PLUS processor card.
5 Insert the header pins into the socket. Seat the pins firmly into the
socket. Do not bend them.
6Use four screws to secure the FLASH module to the 6500PLUS
processor card as shown. Do not overtighten the screws.