Setting Node to Default Configuration
Setting Node to Default Configuration
Introduction | You can set a node to the default configuration in two ways: |
•Set the DFLT switch on the front panel
•Select the Default Node selection from the CTP Main menu
Defaulting the Follow these steps to default the node using the DFLT switch:
Node
Step | Action |
1Push the DFLT switch to the left and press the RESET button.
2Push the DFLT switch to the right when the STATUS light turns steady on and press the RESET button.
3Push the DFLT switch back to the left when the STATUS light turns steady on and press the RESET button.
When the STATUS light turns steady on, the node is set to default values.
For more information about the Default Node menu option, see the Vanguard ONS Basics Protocols Manual
Installation |
