Vanguard Managed Solutions 6500 PLUS Installation, Procedure, Step Action Description/Result

Installing Standalone Units

Installation	The standalone enclosure already contains a 6505PLUS, 6507PLUS, or 6525PLUS card.
Procedure	To install the unit, follow these steps:
	Step		Action		Description/Result
	1	Place the unit at its designated site			The power cord is attached to the
		and plug the power cord into a			back of the unit (Figure 2-2).
		suitable primary power source.
	2	Switch on the power, located at the			The front panel lights turn on
		rear of the unit.			as described in the “Power-Up
					Verification” section on
					page 2-74.
					After a few minutes, the green
					STATUS light comes on to indicate
					the node is ready to process calls.
					If this does not occur, call your
					VanguardMS representative.
	3	Configure the unit through the			To access the CTP, attach a
		Control Terminal Port (CTP)			terminal to Port 6 with an EIA
		menus.			232-D connector. Port 6’s default
					settings are standard terminal port
					values: 9600 baud, 8 data bits, 1
					stop bit, no parity.
	4	When the (*) prompt appears on			This is the default password value.
		the terminal, type the following:			The Main menu appears. See the
		.ctp <CR>			Vanguard ONS Basics Protocols
		At the password prompt, press			Manual (T0106) for configuration
		<CR>			information.
Rear View
	Figure 2-2shows the rear view of the standalone enclosure.
	..
			PORT 6	PORT 5	PORT 4
			PORT 3	PORT 2	PORT 1

Figure 2-2. Rear View of Standalone Enclosure

Installation 2-21