Installation 2-27
Installing Standalone Units
5Take the enclosure cover and connect the power cable to the
backplane connector. Be sure to align the keyed pin on the cable to
the connector.
6Align the enclosure cover and bottom, and press the two gently
together.
This requires alignment of the backplane and the locking tabs. Be
sure that the cables are not pinched between the enclosure and metal
parts. When all elements are correctly aligned, the locking tabs snap
into place.
7Tighten the locknut and washer on the rear panel.
8Insert the four locking clips into the slots.
9Reinstall the door by gently pressing the hinge parts together.
After the card has been properly installed, reconnect the cables and
turn on the unit.
Step Action