Modifying Scenes/Zones

Use the following procedure to modify existing Scenes and Zones in ThinkEssentials®.

To modify a scene or zone:

1.Press-and-hold the left mouse button or right-click the button for the scene or zone you wish to modify.

2.To rename the scene, select the RENAME SCENE or RENAME ZONE option.

3.To modify a scene or zone, select the MODIFY SCENE or MODIFY ZONE option. Follow steps 3 and 4 in “Creating Scenes/ Zones”, page 16-17, to select or de-select devices and re-record the scene or zone.

Removing Scenes/Zones

Use the following procedure to remove Scenes or Zones in ThinkEssentials®.

To remove a scene or zone:

1.Press-and-hold the left mouse button or right-click the button for the scene or zone you wish to modify.

2.Select the REMOVE SCENE or

REMOVE ZONE option respectively.



Right-Click to see option for MODIFY SCENES OR ZONES.



Right-Click to see option for REMOVE SCENE OR ZONE.

Scenes/Zones

Page 18

Image 18

Wayne-Dalton WDSF-10, WDUSB-10R manual Modifying Scenes/Zones, Remove Zone option respectively

Contents

Package Contents USB Z-Wave Adapter USB Stand Software on CD Home Control Basics Table of Contents Basics Copy See Replicate Basics Basics 143 Screen Layout InformationNumber below corresponds to the bubble number above Installation/Setup Install USB Adapter and USB stand into computer USB port Next Use Change Location link to set your physical location Adding Modules to the Network Press ADD Device to add a Z-Wavemodule Hide Pane Button or Design tab to reveal the icon Operation Common Operations Again Drawing Floor PlanButton in the Design pane. This Erase Press Remove Device to remove a Z-Wavemodule Remove/Replace Broken Modules To remove the module fromRight-click and select Remove Broken Device Operations Use the following procedure to lock/unlock ThinkEssentialsLocked mode the software Locking/Unlocking ThinkEssentials Scenes/Zones To include modules into this scene Modifying Scenes/Zones Remove Zone option respectively Schedules Select Scene/Zone and Action desired   Activated Pages LinkModify the desired fields per Instructions in the section Items Network Operations Joining ThinkEssentials to Existing Networks Example Primary ControllerInitiate Primary Controller to Send Replication Adding a Controller To the network Secondary ControllerPress ADD Device to add a secondary controller Device removed successfully message window Updating Secondary Controllers Advanced Operations Optimize/Repair NetworkPolling Example Portable Controller Transfer Primary Role From ThinkessentialsInitiate Transfer in ThinkEssentials Confirmation of successful transfer Transfer Primary Role To Thinkessentials On Settings tab, select Switch to or JoinController Shift command CONTROLLER, or Controller Shift Backup Network Settings Configuration Backup file Restore commandClick the Backup or Restore Network Settings link Wayne-Dalton USB Z-Wave Section on the Settings tab Located. Note The default parent directory isCommand line window Before you begin, you must Exit Adding Command Line Option to ThinkEssentials Shortcut Start ThinkEssentials using the ThinkEssentials iconModify the Target , then click on APPLY, then OK Type in the /multi command line option Command Line Option Multiple Z-WaveUSB AdaptersInitiate command line function ThinkEssentials /multi Initiate command line function Shortcuts Press F5 to refresh and poll the network Exiting/Closing To reset the USB Z-Wave Adapter Factory ResetResetting Thinkessentials Again On the Settings tab, click on the Reset link Troubleshooting Then select the module again It is enabled on the desired days of weekIf the modules’s icon is covered by a red Some modules do not support Switched on Set up your network againCheck to make sure that there is power Controller to my network. Now, neither Compliance US and Foreign Patents pending