Basics 143, Screen Layout Information | Wayne-Dalton WDUSB-10

Screen Layout Information

1

2	12	4

8

Basics

7 9

11

143

10

13

6	5

The number below corresponds to the bubble number above.

1.Minimize, Maximize and Close Buttons control Wayne-Dalton ThinkEssentials® window.

2.Home Tab for application operations and Settings Tab for global software settings.

3.Design, Scenes and Zones Tabs for specific tasks within the Home Tab

4.Specific task Buttons within each Task tab.

5.Hide Pane Button to hide task buttons.

6.Lock/Unlock Button.

7.Example of Floor plan showing multiple named rooms.

8.Example of Slider Bar to adjust dim level on a dimming module.

9.Example of highlighted Switch indicating module is ON.

10.Example of greyed out Switch indicating module is OFF.

11.Example of Thermostat module.

12.Example of greyed out module that has dimming capability indicating it is OFF.

13.Example of highlighted duplex switch module indicating it is ON.

14.Example of window shade module icon.

5

Image 5

Wayne-Dalton WDUSB-10, WDSF-10 Basics 143, Screen Layout Information, Number below corresponds to the bubble number above

Contents

Home Control Basics Package Contents USB Z-Wave Adapter USB Stand Software on CD Table of Contents Copy See Replicate Basics Basics Number below corresponds to the bubble number above Basics 143Screen Layout Information Install USB Adapter and USB stand into computer USB port Installation/Setup Use Change Location link to set your physical location Next Press ADD Device to add a Z-Wavemodule Adding Modules to the Network Hide Pane Button or Design tab to reveal the icon Operation Common Operations Button in the Design pane. This Drawing Floor PlanAgain Erase Press Remove Device to remove a Z-Wavemodule Right-click and select Remove Broken Device Remove/Replace Broken ModulesTo remove the module from Locked mode the software Use the following procedure to lock/unlock ThinkEssentialsOperations Locking/Unlocking ThinkEssentials Scenes/Zones To include modules into this scene Remove Zone option respectively Modifying Scenes/Zones Select Scene/Zone and Action desired Schedules Activated   Modify the desired fields per Instructions in the section LinkPages Items Joining ThinkEssentials to Existing Networks Network Operations Initiate Primary Controller to Send Replication ExamplePrimary Controller Press ADD Device to add a secondary controller Adding a Controller To the networkSecondary Controller Device removed successfully message window Updating Secondary Controllers Polling Advanced OperationsOptimize/Repair Network Initiate Transfer in ThinkEssentials Transfer Primary Role From ThinkessentialsExample Portable Controller Confirmation of successful transfer Controller Shift command On Settings tab, select Switch to or JoinTransfer Primary Role To Thinkessentials CONTROLLER, or Controller Shift Configuration Backup Network Settings Click the Backup or Restore Network Settings link Restore commandBackup file Wayne-Dalton USB Z-Wave Command line window Located. Note The default parent directory isSection on the Settings tab Before you begin, you must Exit Modify the Target , then click on APPLY, then OK Adding Command Line Option to ThinkEssentials ShortcutStart ThinkEssentials using the ThinkEssentials icon Initiate command line function Command Line Option Multiple Z-WaveUSB AdaptersType in the /multi command line option ThinkEssentials /multi Initiate command line function Press F5 to refresh and poll the network Shortcuts Exiting/Closing Resetting Thinkessentials Factory ResetTo reset the USB Z-Wave Adapter Again On the Settings tab, click on the Reset link Troubleshooting If the modules’s icon is covered by a red It is enabled on the desired days of weekThen select the module again Some modules do not support Check to make sure that there is power Set up your network againSwitched on Controller to my network. Now, neither US and Foreign Patents pending Compliance