Whirlpool MFW 9700S, MFW 9600S manual $%&%*$% ,&## 2$&+1234546#2&%2$!#2 &-.0$$+&. /+2+$ &+&+$�

12 1234526782695￿￿￿6￿￿￿2

3Drape the power cord over the washer top.

Secure the drain hose to the laundry tub leg or standpipe with the beaded strap provided. (See illustrations A and B.)

If the washer faucets and the drain standpipe are recessed (see illustration C), put the hooked end of the drain hose in the standpipe. Tightly wrap the beaded strap around the water inlet hoses and the drain hose.

Do not force excess drain hose into the standpipe.

￿2￿2￿67826￿￿￿825

Properly leveling your washer avoids excessive noise and

12vibration.

Check the levelness of the washer by placing a level on the top edge of the washer, first side to side, then front to back.

If the washer is against a wall, move the washer out slightly before tipping back. If the washer is not level, first prop the front with a wood block and adjust the feet as necessary; then prop the back and adjust feet as necessary. Repeat this

32step until washer is level.

Make sure all four feet are stable and resting on the floor.

4Then check that the appliance is perfectly level (use a level).

After the washer is level, use a 17 mm open-end wrench to turn56789￿￿￿￿￿the nuts on the feet tightly against the washer cabinet.

All four feet must be tightened. If the nuts are not tight against the washer cabinet, the washer may vibrate.

The washer should not move front to back, side to side, or

2diagonally when pushed on its top edges.

￿Slide the washer to its final location. Confirm the levelness of the washer.

12	￿￿￿￿￿2726￿￿￿7￿￿￿￿7￿￿￿
	Check the electrical requirements. Be sure that you have the
	correct electrical supply and the recommended grounding
32	method. See “Electrical Requirements.”

Check that all parts are now installed. If there is an extra part,

4go back through the steps to see which step was skipped. Check that you have all of your tools.

Dispose of/recycle all packaging materials.

￿2Check that the water faucets are on.

Check for leaks around faucets and inlet hoses.

7￿$%￿&￿￿)%￿*￿$%,&#￿#￿￿￿￿￿￿￿￿￿￿'￿￿2$&+1234546￿￿'￿￿￿￿#2￿&%2￿￿$￿!"￿￿#￿￿￿￿2 (￿&￿-.￿￿￿0￿￿￿￿￿￿￿￿￿￿￿￿￿￿$$+￿￿&￿￿. /￿+￿￿￿￿2+￿￿$￿￿￿￿&+￿￿￿&￿￿￿+$￿￿￿￿&￿#￿￿￿￿0￿

Plug into a grounded 3 prong outlet.

Read “Washer Use.”

To test and to clean your washer, measure The detergent manufacturers Recommended amount of HE High Efficiency

detergent for a medium-size load. Pour the detergent into the detergent dispenser. Select NORMAL/CASUAL, and then select HOLD TO START. Allow the washer to complete one

whole cycle1234567849. ￿49￿￿￿4￿￿￿￿￿￿36￿84￿3￿3￿￿36￿￿

2-6