Whirlpool MFW 9600S, MFW 9700S manual Front Slot Front Holes

18.Using the procedure in step 13, remove the two front shock absorbers from the tub.

19.Lift the tub and basket assembly and un- hook the two suspension springs, then remove the assembly from the washer, and place it front-down on a padded sur- face so that the back pulley faces up. NOTE: The suspension springs are in- stalled in the front slots of the cabinet, as well as in the tub. Do not use the back slots; they are used with other models.

Front Slot Front Slot

Front Holes

21.Mark the edges of the 23 tub clamps with a pencil so that you can reinstall the clamps in the same locations later.

22.Use a screwdriver blade, and pry off the 23 tub clamps.

Tub Clamp

20.Remove the 15/16 inch hex-washer nut from the drive pulley and remove the pul- ley from the basket shaft.

	Drive Pulley Nut
Drive Pulley

Pencil Marks
	Screwdriver

Tub Clamp Pry Clamp Out

Continued on the next page.

4-26