Xerox 4510/4510ps manual Point Size, Default Source, 12.00, Handling Paper, Selecting a Paper

P C L M e n u

Figure 3.10 PCL Menu options showing factory settings (continued)

Option	Setting	Description
Point Size	4.00 - 999.75 by .25	Point size (a measurement for type height, 1 point
	(12.00*)	equals 0.351 mm or approximately 1/72 inch) for the
		font represented by Font Number (page 3-20).
		Appears only when the Font Number setting
		specifies a scalable proportional spaced font, such as
		Times New Roman.
		Most software applications override this setting. If
		your application does not, the printer assumes the
		default setting here.
Default Source	Standard*	Default paper source in PCL if none is specified by
	Manual (MP)	your software application.
	Lower†	The printer uses Default Source when there is no
		paper source specified in the print job. Some software
		applications have a paper source selection called
		“Auto Select” or “Auto Sheet Feed” which usually
		results in the omission of a paper source selection in a
		print job.
		When the printer uses Default Source, Source
	† Appears only when an	Mapping (page 3-22) is used to determine the actual
		tray or slot from which the printer pulls paper. See
	optional lower base is	Chapter 2: Handling Paper, “Selecting a Paper
	installed.
		Source” (page 2-22)for more information on the
		interaction of Default Source and Source Mapping.

C h a p t e r 3 : U s i n g t h e C o n t r o l P a n e l ❖ 3-21