Xerox 4510/4510ps, 4505/4505ps manual Printer controller board and the chassis

Inspect this area to verify that there is no gap between

the printer controller board and the chassis.

I n s t a l l i n g a S I M M

16 Ensure that the controller board is touching the rear of the printer chassis. There must be no space between the controller board and the chassis.

Use only finger pressure to tighten the thumbscrews. Do not

!use a screwdriver because the threads will be stripped if excessive torque is applied. The screwdriver slot in the

Caution thumbscrew is only there to start the disengagement of the controller board after an extended period of time when

fingers may not be able to disengage it.

C h a p t e r 5 : A d d i n g P r i n t e r O p t i o n s ❖ 5-13