S e l e c t i n g a P a p e r S o u r c e

Source Mapping Examples

Review the following Source Mapping examples to take full advantage of the 4505/4505ps and 4510/4510ps capabilities.

All examples assume that Default Source is set to Standard.

Example 1

You do not have a lower base installed. You want to load as

much paper in the printer as possible. You use only one size

 

 

of paper. You do not do manual feeding.

 

1.

Load the standard and MP trays with regular paper stock.

 

2.

Set Source Mapping for “Standard” to “Standard-MP.”

 

3.

Set MP Tray Size to the same size as the regular stock.

 

4.

In either your software application or the Xerox printer

 

 

driver, set paper source to the standard tray.

 

The printer will pull paper from the standard tray until it is

 

empty, then from the MP tray. When the standard tray is

 

reloaded, the printer will pull paper from it again.

 

 

 

The Source Mapping setting determines from where the

 

printer pulls paper.

Note

For the paper sources you intend not to use, always set Source

Mapping to the same setting as that used for your regular paper stock. You will avoid unexpected results if those paper sources are used by mistake.

The examples suggest using specific PCL paper sources but generally you may substitute any source to fit your printing needs.

Note

C h a p t e r 2 : H a n d l i n g P a p e r 2-27

Page 39
Image 39
Xerox 4510/4510ps, 4505/4505ps manual Source Mapping Examples