Xerox 4510/4510ps, 4505/4505ps manual Frame Type, 802.3, Correct frame type

I n t e r f a c e M e n u

Figure 3.17 Ethernet Menu options showing factory settings (continued)

Option	Setting	Description
Auto Job End	Off	Automatic ending of a print job that does not finish.
	On*	When On, after the current print job has paused long
		enough to exceed the Port Timeout (page 3-51)
		interval and no data has been received on any other
		port, the print job will be stopped. Any partial page is
		ejected from the printer and the print job is cleared
		from memory.
		Use Auto Job End On when the printer serves
		multiple users on a network. This assures that one
		user’s print job will finish and all pages will exit the
		printer whether or not another user sends a print job.
		No partial pages will be left unprinted.
		When Off, the print job does not end after the
		timeout interval. Instead, the printer waits to continue
		until another print job is received on any port. A
		partial page will remain unprinted until the next print
		job is received. See Form Feed	(page 3-6) for
		information on ejecting partial pages.
		Auto Job End should be On if the printer
		is on a network.
		Note
		If you are not sharing the printer with other users and
		if you find that one page is split and printed on
		multiple pages, set Auto Job End Off or increase the
		Port Timeout interval. It could be the Port Timeout
		is exceeded before the rest of the page can be sent.
		Also see “Printer Settings that Affect Memory”
		(page 3-67)for other ways to correct the problem of
		one page printing on multiple pages.
Frame Type	802.3*	Protocol standard frame type.
Note: This option is	Ethernet II	Refer to your network software documentation for
available for firmware		the correct frame type.
release 4.0 only. To
determine the firmware
release of your printer,
print a Configuration
Sheet.

C h a p t e r 3 : U s i n g t h e C o n t r o l P a n e l ❖ 3-53