Xerox 50 manual 3 4 5 6 7, Sample timeout setting screen, Tools Mode, 3–40

Models: 50

1 138
Download 138 pages 36 Kb
Page 94
Image 94
Figure 61: Sample timeout setting screen
Touch Close to display the Tools screen.
Touch Close to save the settings and display the Timeouts screen.
4
5 If necessary, repeat steps 2 through 4 for other timeout settings.
6
To re-enable an option that was previously disabled, use the up arrow to set a new time.
Perform one of the following:
Use the up and down arrows (Figure 61) to increase or decrease the desired time before returning to the default settings after a job is complete or only partially programmed, entering Low Power mode, powering off, or exiting System Administration mode. Be sure to stay within the stated minimum and maximum times.

3

1

Figure 61: Sample timeout setting screen

2

Touch the Timeout Disabled button to prevent the machine from timing out.

NOTE: The disable option is not available on the Low Power Timeout or Auto Power Off screen. If the copier/printer is not used for over four hours (default setting), it must enter Low Power mode.

3

4

5

6

7

TOOLS MODE

3–40

DOCUMENT CENTRE CS 50 SYSTEM ADMINISTRATION GUIDE

Page 94
Image 94
Xerox 3 4 5 6 7, Sample timeout setting screen, Tools Mode, 3–40, DOCUMENT CENTRE CS 50 SYSTEM ADMINISTRATION GUIDE