Xerox CX240, CX250 Image Position, Image Scale, Rotate, ¾ To rotate your job by 180, select Yes

178 Appendix A– Setting Parameters

Image Position

This parameter enables you to change the location of the entire printed image on the sheet (simplex or duplex).

Image position uses the following terminology:

•Rear: the edge of a sheet at which printing stops, near the rear of the printer

•Lead: the edge of a sheet at which printing begins

The page’s lead and rear edges are determined just after the page is printed out, before making any change in page orientation.

¾Select one of the following:

ˆTo print your job in the center of the page, click Center

ˆTo set page offsets, click the directional arrows or type Rear and Lead values

¾To apply page offset values to both odd and even pages, select the

Same on both sides check box.

Tip: Use this option to move duplex page data away from the spine.

Image Scale

¾Perform one of the following:

ˆTo print the image original size, select 100% (default)

ˆTo fit the image to the selected paper size, select Fit to Paper

ˆTo custom size the image, select Custom and type the percent by which you would like to proportionally increase or decrease the image size

Rotate 180

¾To rotate your job by 180°, select Yes.