Xerox CX250, CX240 manual Finisher

Setting Parameters in the Job Parameters Window 205

ˆPrint on back side: prints the last page of the job as the back cover

ˆPrint on both sides: prints the last two pages of the job as the back cover

Finisher

The Finisher parameter enables you to select the destination of the printed output.

Note: The available stapling methods for PostScript files depend on the page orientation and size. The stapling methods for PDF files depend on the page size.

¾Select an Output Tray:

ˆSCT (simple catch tray)

ˆOCT (offset catch tray)

•The Offset check box is selected by default. If you don’t want to use an offset between sets, clear this check box.

ˆTop Tray

•The Offset check box is selected by default. If you don’t want to use an offset between sets, clear this check box.

•To punch holes, select the Puncher check box, and select the number of holes in the Type list.

ˆStacker

•The Offset check box is not selected by default. If you want to use an offset between sets, select this check box.

•To use staples, select the Stapler check box, and in the Position list, select the staple position.

•To punch holes, select the Puncher check box, and select the number of holes in the Type list.

ˆBooklet Maker

•To use staples, select the Stapler check box, and in the Position list, select the staple position.