Duplex Unit
6-36 ❖System Administrator Guide
4Lift the duplex unit towards you and free its two stubs
from the printer.
5Remove the duplex unit from the printer.
Be careful not to touch the fuser. It becomes
very hot from printing.
6Reinstall the side cover by (1) lining up the tab,
(2) pushing up, (3) while pushing in, and (4) sliding it
into place.
7Close the rear cover.
8Reconnect the printer’s power cord and power on the
printer.
9Check the Control Panel display. When the printer has
completed its power on diagnostics, the display should
show Ready. If an error message is displayed, refer to Table
5.1 on page 5-5 for instructions.
2
1
3
4