Using the Menu System
Chapter 1: Configuring the Printer ❖1-77
Port Timeout
Set the time for determining when to
end an incomplete print job and poll
the next port in the polling sequence.
The available values are:
5 - 300 seconds (60*)
This item also causes an implicit job
end such as Control D in PostScript or
<ESC> E in PCL, and invokes the
emulation functions associated with
this action (e.g., formfeed, reset, etc.).
The time changes incrementally by 1
second each time either Value U p or
Value Do wn is pressed. Holding
down Value U p or Valu e Dow n
causes continuous scrolling through
the values.
1.Press Menu Up or Menu
Down until you see: Menus
Ethernet Menu
2.Press Item Up or Item Down
until you see: Ethernet Menu
Port Timeout
3.Press Valu e Up or Va lue Down
until you see: Port Timeout =
New Value
4.Press Enter. You will see: Ethernet Menu
Port Timeout
5.Press Online. You will see: Ready
Speed
Set the speed of the 10/100 Ethernet
interface (does not appear if the
10Base2 option is installed).
The available values are:
Auto*
10/HALF
10/FULL
100/HALF
100/FULL
HALF = Half duplex Ethernet mode
FULL =Full d uplex Ethernet mode
1.Press Menu Up or Menu
Down until you see: Menus
Ethernet Menu
2.Press Item Up or Item Down
until you see: Ethernet Menu
Speed
3.Press Valu e Up or Va lue Down
until you see: Speed =
New Value
4.Press Enter. You will see: Ethernet Menu
Speed
5.Press Online. You will see: Ready
Table 1.23 Ethernet Menu Functions (continued)
Menu Item and Function Keystrokes Display
Table1.23 Page12 of 12