Interface Card
Chapter 6: Installing Printer Options ❖6-47
10 Secure the access cover with its screws.
11 Reinstall the side cover by (1) lining up the tab,
(2) pushing up, (3) while pushing in, and (4) sliding it
into place.
12 Close the rear cover.
13 Reconnect the printer’s power cord and power on the
printer.
14 Check the Control Panel display. When the printer has
completed its power on diagnostics, the display should
show Ready. If an error message is displayed, remove and
reinstall the drive. If the problem persists, contact your
Customer Support Center.
15 If you have no other options to install, print a
Configuration Sheet (see page 1-102) and check it to
confirm that the option(s) have been properly installed.
2
1
3
4