Using the Menu System
Chapter 1: Configuring the Printer ❖1-39
Form Length
Set the default text length (number of
lines on a page) used in PCL.
The available values are:
5 - 128
(60* when Defaults = Inches)
(64* when Defaults = Millimeters)
Form Length is automatically adjusted
when Paper Size is changed. The
Form Length is recalculated using the
formula: Form Length = ((page length
in inches - 1 inch) * 6).
The Form Length value changes
incrementally by 1 each time either
Value Up or Value Down is pressed.
Holding down Value Up or Value
Down causes continuous scrolling
through the Form Length values.
The value of this setting after
performing a Factory Reset depends
on the value of the Default units
(inches, millimeters).
1.Press Menu Up or Menu
Down until you see: Menus
PCL Menu
2.Press Item Up or Item Down
until you see: PCL Menu
Form Length
3.Press Valu e Up or Va lue Down
until you see: Form Length =
New Value
4.Press Enter. You will see: PCL Menu
Form Length
5.Press Online. You will see: Ready
Table 1.13 PCL Menu Functions (continued)
Menu Item and Function Keystrokes Display Reads
Table1.13Page5 of 6