Creatingi Plugl -ininCustom Voicesi
■Using the Plug-in voices in Song Creator
See page 125.
■Differences between the PLG150 and PLG100 series
(Single Part Plug-in Boards)
If you intend to use Single Part Plug-in Boards, Yamaha recommends that you use the PLG150 series boards exclusively. For this reason, the included floppy disk features voice data for PLG150 series Plug-in Boards. However, you can use the PLG100 series if you keep in mind the following points and anomalies.
●Poly Expansion (page 69)
If you have installed a PLG150 Board to SLOT 1 and a PLG100 Board to SLOT 2 (or, in other words, installed a higher level board of the same type to SLOT 1), and have set POLY EXPANSION to ON, you may experience certain problems when playing the voices.
When you have installed a PLG150-DX to SLOT 1 and a PLG100-DX to SLOT 2:
No problem should result when using the installed voices in both boards; however, if you try to play voices that do not exist on the PLG100-DX (SLOT2), the sound may drop out period- ically. Make sure to use only those voices that are common to the two boards.
When you have installed a PLG150-VL to SLOT 1 and a PLG100-VL to SLOT 2:
If the Breath Mode of the PLG150-VL Native Part parameters (a parameter that does not exist on the PLG100-VL) is set to a value other than "System,” the volume and timbre of the played voice changes every other note. Make sure to set the Breath Mode to "System" in this case.
●Data compatibility
The Board Custom Voices are not available in PLG100 series boards. As a result, data related problems will occur when loading the voice data from disk to Flash ROM with the Plug-in Manager function.
When you install the PLG100 series voice data with a PLG150 Board installed:
The Plug-in Voice using the Board Custom Voice may not sound appropriately, if the Board Custom Voice has been edited and Board Custom Backup has been executed.
This is because the PLG100 series voice data does not contain the Board Custom Voice data.
When you install the PLG150 series voice data with a PLG100 Board installed:
•The Board Custom Voice data loaded from disk is not used. Therefore, voices using this data may sound different than expected or than originally programmed.
•If a PLG100-DX board is installed and you select a voice based on a voice that does not exist on the PLG100-DX board, no sound results.
•The Breath Mode setting of the PLG150-VL Native Part parameters is ignored, and the Breath Mode setting of the PLG100-VL Native System parameters is available.
■Setting the Unison Switch of the PLG150-AN board to on
Plug-in Voices of the PLG150-AN for which Unison Switch (of the Native System parameters) has been set to on, cannot be played polyphonically — even if the 9000Pro’s POLY/MONO button is set to POLY. Note that many of the Plug-in Custom Voices in the included disk are deliberately set to Unison On, to effectively recreate popular monophonic synthesizer sounds.
Reference 109
