Samplingli

■Pre Effect

You can set up a maximum of three DSP effects to be applied to the source sound as it is sampled. The DSP blocks are connected in series as shown below. The following display will be shown in step #10 on page 40.

Select the desired DSP block.

Select the desired type of the selected DSP block.

Press this button to switch between the currently selected wave and the currently selected panel voice.

Select this to call up the storing display.

Change the balance between the direct (dry) and effect (wet) sound.

Select the parameter and adjust the value of the selected parameter.

Note that the contents of the parameter may be different depending on the selected DSP type.

Importing Wave Files from Disk

To import previously saved waveform files via the PSR-8000 or standard WAV or AIFF format files from disk, insert the appropriate disk into the 9000Pro floppy disk drive, then press the [FILE IMPORT] LCD button in step #3 in "Basic Procedure" on page 86.

Select this and press the [NEXT] button to call up the display that imports the WAV or AIFF format file.

Select this and press the [NEXT] button to call up the display that imports the wave data sampled via the PSR-8000.

Clearing Wave Data

The explanations here apply to step #4 of the Basic Procedure on page 86.

Press this button to switch between the currently selected wave and the currently selected panel voice.

Select this to execute the

Clear operation.

Reference 87

85