MIDII I Functionsi

■Full Setup

You can create your original settings and store them as a template.

Follow the on-screen instructions to call up the template display as shown below.

PAGE CONTROL

 

BACK

NEXT

 

● Assign various functions to the five

● Assign various functions to the five

Foot Controllers.

 

Footswitches.

PAGE CONTROL

BACKNEXT

Select the desired function to be assigned to the selected Foot Con- troller.

Select the desired function to be assigned to the selected Footswitch.

Select the desired Foot Controller.

PAGE CONTROL

Select the desired Footswitch number.

BACKNEXT

●Select the destination template.

PAGE CONTROL

BACKNEXT

Store the MFC10 settings by following the on-screen instructions.

Press the [NEXT] button to enable the selected Easy Setup template.

Disconnect the MIDI cable from the MIDI OUT B terminal and connect it to the MFC10 Foot Controller.

•Since all MFC10 settings data is stored to Flash ROM, any data in the MFC10 settings location will be erased and replaced by your new settings. This includes the factory pro- grammed preset MFC10 settings. If you’ve deleted the factory-set data, you can use the Restore function (page 154) to load a copy of it from the included disks (page 6).

•When setting up the MFC10 from the 9000Pro, a MIDI cable must be connected from the MIDI OUT of the 9000Pro to the MIDI IN of the MFC10. However, you should disconnect this cable when using the MFC10, since extraneous MIDI messages may be transmitted from the 9000Pro.

•To exit from the MFC10 play mode, select the MIDI Template display (page 174) and press the [CANCEL] LCD button.

•The MFC10 play mode on/off status is retained in Flash ROM and is maintained even when the power is turned off.

Reference 179

177