InstallingI lli Optionali l Hardware
Optional Hard Disk Installation
The hard disk used must be a
CAUTION
•When inserting hard disk unit and connecting cables, make sure that you check that they are inserted and connected properly. Improperly inserted hard disk unit and cables may cause faulty contacts and an electri- cal short circuit which may cause damage or result in a malfunction.
•After mounting the hard disk unit, be sure to tighten the screws as directed so it is completely stable and does not move in any way.
•Hard disk drives of a maximum 8 GB capacity can be formatted; however, the maximum partition size is 2 GB. For example, an 8 GB hard disk drive would have to be formatted into four separate 2 GB partitions.
•Hard disk drives of a capacity greater than 8 GB can be installed; however, the 9000Pro is capable of formatting only up to a maximum 8 GB on the drive.
•Hard disk drives wider than 12.7 mm cannot be installed to the 9000Pro.
For information on the hard disk recommendations, ask your nearest Yamaha representative or an authorized distributor listed at the end of this owner’s manual. Install a hard disk at your own risk. Yamaha will not be held responsible for any damage or injury resulting from improper installation or the use of a hard disk other than one of the types recommended by Yamaha.
1-4
WARNING
•In order not to drop any screws inside the 9000Pro, keep the
If the
5 Remove the four screws from the 
6 Turn over the Silver screws
This is the location for the Hard disk unit.
If a
7 Hold the hard disk unit in place with your hand as shown below. Make sure that the socket end of the unit faces toward you as shown.
Hard disk unit: top side face up
Turn over | Align the holes in the cover with the |
| holes on the hard disk. The actual |
| placement of the holes may differ |
| depending on the particular hard disk. |
184Reference
182