InstallingI lli Optionali l Hardware

8 Unfasten the cable inside the 9000Pro as shown in the following illus- tration.

There are three cables available for installation. The two smaller cables are used for the Plug-in Boards; the larger cable is for the hard disk.

Cable clip

9 Carefully plug the cable connector into the Plug-in board connector until the two notches on the cable connector lock into the sockets on the board as shown in the illustration.

The two cables can be used interchangeably. The cable that is used determines the slot number used by the 9000Pro. The cable with the single orange cord corresponds to Slot 1. The cable with the yellow cord corresponds to Slot 2. Keep in mind that the slot number is determined by the cable, not the actual installation position of the board.

First board

Second board

Orange or yellow

Yellow or orange

Colored side of cable faces inward.

 

 

10 Attach the Plug-in board/Hard disk cover to the 9000Pro.

Black screws

Bring the cover back around as shown, so that the board fits in properly.

11 Check that the installed Plug-in board is functioning properly.

Turn on the power.

•A message appears indicating that the installed Plug-in Board is being initialized. The main display then appears, indicating that the board has been successfully installed.

•If an error message appears, the 9000Pro freezes after a while, indicating that the installation was not successful. If this happens, turn off the power and carefully go through the installation proce- dure again.

•If you cannot select a Plug-in Voice even though no error message appears, the board has proba- bly not been connected. If this happens, turn off the power and make sure that the Plug-in Board is securely connected.

Reference 183

181