■Track Mixing

This function allows data from two tracks can be mixed and the results placed in a different track , or data to be copied from one track to another.

Press this to execute the Track Mix operation.

After execution the this button changes to an UNDO button which can be used to undo the copy/mix operation if the results are not satisfactory (the “UNDO” button will only remain active until the next operation is performed).

Specify the tracks to be mixed.

Select the track into which the

 

results will be placed.

To simply copy from the SOURCE1 track to the DESTINA-

TION track select COPY via the SOURCE2 LCD buttons.

Song Creator

•All data other than the mixed note data is derived from the SOURCE1 track.

•The Part Assign parameters of the Plug-in Voice are not cop- ied to the destination part even if the Track Mix operation is executed. Therefore, set the Part Assign parameter (in the System Exclusive - XG param- eters) to the corresponding Part number in the Event List display (page 120) after exe- cuting the Track Mix operation. For details about the Part Assign parameters, refer to the Owner's Manual of your Plug- in Board.

■Note Shift

This allows tracks which contain data to be individually transposed up or down by a maximum of two octaves in semitone increments.

The TR1~8/TR9~16 LCD button can be used to switch between tracks 1 through 8 and tracks 9 through 16.

Adjust any track while holding this button to set the note shift for all tracks simultaneously.

Set the desired amount of transposition for each track (note-shift controls will only appear for tracks which contain data).

Press this to execute the Note Shift operation.

After execution this button changes to an UNDO button which can be used to undo the Note Shift operation if the results are not satisfactory (the “UNDO” button will only remain active until the next operation is per- formed).

Song Setup (Multi Track Recording)

This function lets you assign the DSP effect block (4~7) to any of the current song’s tracks. Other parameters can be modified up as required via the MIXING CONSOLE display (page 144).

The tempo of the song can be set as required via the Data dial, and all other available parameters can be modified as required via the MIXING CONSOLE displays.

Assign the DSP effect block (4~7) to any of the current song’s tracks.

Press this to record the settings to the current song.

•Only one of the Setup parame- ters can be recorded to each track, and any parameter changes made in the middle of the song will be cancelled. However, in the case of Volume and Tempo data, any Volume and Tempo changes in the mid- dle of the song are applied as an offset to the initial Setup Data setting.

Reference 115

113