Connect a lamp to one of the terminals on the rear panel. Firmly push the lamp connector into the socket until it locks.
Lamp

The 9000Pro features two Lamp terminals (at either end of the rear panel) for connecting an optional lamp. This is especially convenient when using the 9000Pro in situations of low available light. To turn on the lamp, use the switch/dimmer control at the left end of the rear panel (as viewed from the keyboard side).

Startingi Up

WARNING

To avoid possible damage to the instrument, follow these precautions:

•Only use lamps that conform to the specifications listed at left.

•Do not attempt to insert any- thing other than a proper lamp to the Lamp terminals.

•Do not short-circuit the ter- minals.

•Do not apply electrical volt- age (power) to the Lamp ter- minals.

Either or both terminals can be used, letting you connect up to two lamps.

0 - 10V DC

Pin 1, 2: No connection

Pin 3, 4: 0-10V DC

Use this to turn the lamp on and off and control the brightness.

WARNING

• Make sure the gooseneck of

the lamp is 12 inches or

shorter. Goosenecks of

longer lengths may be unsta-

ble.

• The connected lamp

becomes very hot after

Only use lamps conforming to the following specifications:

•Lamp: 12V 5W

•Connector: 4-pin XLR

1 Make sure that the POWER switch is off.

2

3 Turn the power on by pressing the [POWER] switch. 4 Use the [DIMMER] control to turn the lamp on.

To disconnect the lamp:

First, make sure the lamp is off (the [DIMMER] is set to OFF ), then unplug the lamp while holding down the PUSH latch on the rear panel.

being on for a while. Make

sure you let the lamp cool

before trying to touch it.

•The light bulb will burn out over a long period of use. When this happens, replace the bulb with a new one. You can extend the life of the bulb by turning the [DIMMER] control down toward [MIN] when using the lamp.

15

13