InstallingI lli Optionali l Hardware

5-[3] Holding both edges of the SIMM module, raise it to the vertical position until it firmly locks in place with the left and right clamps.

CAUTION

•Make sure that the entire length of the SIMM is evenly inserted.

Clamp

Clamp

5....................................................................................................................-[4] After confirming the orientation, insert the second SIMM into

 

Second SIMM

 

 

the front slot (the slot closest to the 9000Pro keyboard), and

 

 

raise it to the vertical position in the same way as the first

 

 

SIMM.

SIMM cover

Black screws

6 Replace the SIMM cover and attach it to the 9000Pro with the six screws.7 Check that the installed SIMMs are functioning properly.

Set the 9000Pro right-side up, and connect the power cord to the rear-panel AC INLET jack and an AC outlet.

Turn on the power, go to the SAMPLING display (page 41), and check that the REMAIN TIME value matches the amount of installed memory, as fol-

lows:

 

• 4MB x 2

106.9s

• 8MB x 2

202.1s

• 16MB x 2

392.3s

• 32MB x 2

772.7s

• No SIMMS

11.8s

(These values apply when there is no data in the wave memory.)

■Removing SIMMs

SIMM modules can be removed after opening the clamps at both ends of the connector slot.

•Although the wave memory of the 9000Pro can be expanded to 65 megabytes, the maxi- mum size of a single sample recording is 32 mega bytes (380 sec.).

Reference 187

185