Yamaha RX-V3800 Using examples, 102 En, Loading by the SET MENU operation, Saving each setting

Saving and recalling the system settings (System Memory)

■Loading by the SET MENU operation

1Press GSET MENU on the remote control.

The top menu appears in the GUI.

2Press 4k / n repeatedly to select “System Memory” and then press 4h.

The “System Memory” menu appears in the GUI.

3Press 4k / n to select “Load” and then press 4h.

The following menu appears in the GUI.

	Sci-Fi
	SpeakerCH 3/2/0.1
Current	LFE Level	0dB
Memory1	D-Range	MAX
	PEQ YPAO Natural

Memory2

4Press 4k / n repeatedly to select the desired memory number where the system settings are stored and then press 4h.

Once “Load: ENTER” appears in the GUI, press 4ENTER to confirm the loading.

y

You can cancel the loading by pressing 4l.

Memory1

Pure Direct

Memory2	SpeakerCH 5/4/0.1
Memory3	LFE Level	0dB
Memory4	D-Range	MAX
	PEQ YPAO Flat

Memory5

5Press GSET MENU to exit from GUI screen.

Using examples

■Example 1: Comparing the results of the

automatic setup and manual setup

This unit is equipped with three types of parametric equalizer settings (see page 40), and you can also make your customized configuration of the sound settings of this unit by using the “Manual Setup” parameters (see

page 85). To compare the results of the automatic setup or your manual configuration, use the NSYSTEM MEMORY buttons.

SYSTEM MEMORY 1

The current settings of this unit

SYSTEM MEMORY 2

The results of the automatic setup (Equalizing: Check:Natural)

	SYSTEM MEMORY
1	2	3	4
CLASSICAL LIVE/CLUB ENTERTAIN			MOVIE
5	6	7	8

SYSTEM MEMORY 3

The results of the automatic setup (Equalizing: Check:Front)

Saving each setting

Note

Carry out the following procedure when all the parameters are set to default values.

1Press and hold NSYSTEM MEMORY 1 for four seconds.

This unit stores the current settings of this unit to “Memory1”.

2Perform the automatic setup.

Set “Equalizing” to “Check:Natural”. See page 40 for details.

3Press and hold NSYSTEM MEMORY 2 for 4 seconds.

This unit stores the results of the automatic setup performed in step 2 to “Memory2”.

4Perform the automatic setup again.

This time, set “Equalizing” to “Check:Front”.

5Press and hold NSYSTEM MEMORY 3 for 4 seconds.

This unit stores the results of the automatic setup performed in step 4 to “Memory3”.

102 En