Yamaha RX-V3800 39 En, Customizing the measurements, If warning message appears, selection

If warning message appears...

	Equalizing		Retry
✓
	Level	Exit	Detail
✓
			Setup
✓ Result
		Measurement Over
		W1:Out of Phase
		W3:Level Error

Warning messages

When this unit detects potential problems during the automatic setup procedure, warning messages appears in the result display. See the “Auto Setup” section in “Troubleshooting” on page 135 for a complete list of warning messages and proper remedies.

6Press GSET MENU to exit from the GUI screen.

Notes

•After you have completed the automatic setup procedure, be sure to disconnect the optimizer microphone.

•The optimizer microphone is sensitive to heat. Keep it away from direct sunlight and do not place it on top of this unit.

■Customizing the measurements

You can select the parametric equalizer type, and activate or deactivate each check items.

1Connect the supplied optimizer microphone to this unit and place the microphone appropriately.

Refer to the steps 1 to 3 of “Basic procedure” on page 41.

2Press 4k to select “Setup Menu” and then

4h.

“Setup Menu” is selected as the currently selected menu item.

3Press 4k / n repeatedly to select “Wiring”, “Distance”, “Size”, “Equalizing”, or “Level”, and then press 4h to set the selected parameter.

4Press 4k / n repeatedly to select the desired parameter and then 4ENTER to confirm the

selection.

5Repeat steps 3 and 4 until you set all the desired parameters.

Optimizing the speaker setting for your listening room (YPAO)

This unit performs the following checks:

Wiring (Speaker wiring)

Checks which speakers are connected and the polarity of each speaker.

Distance (Speaker distance)

Checks the distance of each speaker from the listening position and adjusts the timing of each channel.

Size (Speaker size)

Checks the frequency response of each speaker and sets the appropriate low-frequency crossover for each channel.

Choices: Check, Skip

•Select “Check” to automatically check and adjust the item.

•Select “Skip” to skip the item and perform no adjustments.

Equalizing (Parametric equalizer level)

Parametric equalizer adjusts the level of the specified frequency bands. This unit automatically selects the crucial frequency bands for the listening room and adjusts the level of the selected frequency bands to create a cohesive sound field in the room. You can select the type of the parametric equalizer adjustment from the following choices.

Choices: Check:Natural, Check:Flat, Check:Front, Skip

•Select “Check:Natural” to average out the frequency response of all speakers with higher frequencies being less emphasized. Recommended if the “Check:Flat” setting sounds a little harsh.

•Select “Check:Flat” to average the frequency response of all speakers. Recommended if all of your speakers are of similar quality.

•Select “Check:Front” to adjust the frequency response of each speaker in accordance with the sound of your front speakers. Recommended if your front speakers are of much higher quality than your other speakers.

•Select “Skip” to skip the selected item and perform no adjustments.

Level (Volume level)

Checks and adjusts the volume level of each speaker. Choices: Check, Skip

•Select “Check” to automatically check and adjust this item.

•Select “Skip” to skip this item and perform no adjustments.

y

A check mark appears at the left of the parameter you set other then “Skip”.

PREPARATION

English

39 En