Yamaha RX-V3800 124 En, Remote control TUNER ID, Setting remote control TUNER ID, Press 4ENTER

Advanced setup

■Remote control TUNER ID

RC TUNER ID

Use this feature to set the TUNER ID of this unit for remote control recognition.

Choices: ID1, ID2

•Select “ID1” when the remote control TUNER ID library code is set to “2602”.

•Select “ID2” when the remote control TUNER ID library code is set to “2603”.

Setting remote control TUNER ID

1Set the operation mode selector to DAMP or DSOURCE and then press 1TUNER on

the remote control to select the tuner to change the remote control ID.

2Press and hold MLEARN for about 3 seconds using a ballpoint pen or similar object until “L;TUN” and “TUNER” alternately appear in the display window (B).

LEARN

3 seconds

Notes

•Be sure to press and hold MLEARN for at least 3 seconds, otherwise the learning process will start.

•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 2.

3Press 4ENTER.

The four-digit code set for the selected input area appears in the display window (B) on the remote control.

4Press the numeric buttons (6) to enter the four-digit remote control code for the input area you want to use.

Remote
control	Function	RC TUNER
TUNER ID		ID*2
code*1
2602	Operates this unit using the	ID1
(initial setting)	default code.	(initial setting)
2603	Operates this unit using an	ID2
	alternative code.

*1 The remote control setting.

*2 The setting of this unit.

5Press 4ENTER to set the number.

“OK” appears in the display window (B) if the setting was successful.

“NG” appears in the display window (B) if the setting was unsuccessful. In this case, start over from step 2.

6Press MLEARN again to exit from the setup mode.

LEARN

124 En