Yamaha RX-V3800 38 En, Place the optimizer microphone at your, surface with the omni-directional

Optimizing the speaker setting for your listening room (YPAO)

3 Place the optimizer microphone at your	y
	To stop the automatic setup procedure and set this unit to the
normal listening position on a flat level	pause mode, press one of the cursor buttons (4k / n / l /
	h) or 4ENTER. In the pause mode, press 4kto retry the
surface with the omni-directional
	procedure, and 4l to cancel the Auto Setup procedure.
microphone heading upward.
Optimizer microphone	5 Once all items are set successfully, following
	display appears in the GUI screen.
	✓ Equalizing		Retry
	✓ Level	Exit	Detail
			Setup
	✓ Result
		Measurement Over
		Successfully

y

It is recommended that you use a tripod (etc.) to affix the optimizer microphone at the same height as your ears would be when you are seated in your listening position. You can use the attached screw of a tripod (etc.) to fix the optimizer microphone to the tripod (etc.).

Before proceeding next operation

Once you perform the next operation, this unit starts the automatic setup procedure immediately. For the accurate measurements, once you perform the next operation, we recommend that you get out of the room or move to the position where you do not interrupt the accurate measurements (for example, along the wall with no speakers installed nearby).

•Press 4n and select “Setup” to set the measured values.

•Press 4kand select “Retry” to retry the automatic setup procedure. This unit starts the automatic setup procedure immediately again.

•Press 4h and select “Detail” to view information about measurement results and warning messages. In the information display, press 4k / n repeatedly to toggle between the parameters. For more details about warning messages, see the “Auto Setup” section in “Troubleshooting” on page 135.

•Press 4l and select “Exit” to exit from the Auto Setup procedure. If you select “Exit”, “Don’t Setup?” appears on the screen. To set the measured values and exit, select “Setup”. To cancel the settings and exit, select “Cancel”.

4Press 4ENTER to start the setup procedure.

This unit starts the automatic setup procedure immediately. Loud test tones are output from each speaker during the automatic setup procedure. During the setup procedure, “Measuring...” appears in the GUI screen.

Notes

•During the automatic setup procedure, do not perform any operation on this unit.

•We recommend that you get out of the room while this unit is in the automatic setup procedure. Keep quiet when you leave the room. The necessary time for the automatic setup procedure may differ depending on the environment of the listening room and connected speakers (from 30 seconds to 3 minutes).

y

If you are not satisfied with the results or want to manually adjust each parameter, set the parameters in “Basic” (see page 91).

Notes

•If you change speakers, speaker positions, or the layout of your listening environment, run “Auto Setup” again to recalibrate your system.

•The distances displayed in the “Distance” results may be longer than the actual distance depending on the characteristics of your subwoofer or external amplifiers if you connect them.

•In the “Equalizing” results, different values may be set for the same band to provide finer adjustments.

38 En