Yamaha RX-V3800 owner manual Changing source names in the display window, 110 En, to rename

Remote control features

5Press and hold the button you want to program on the other remote control until “OK” appears in the display window (B) on the remote control.

“NG” appears in the display window (B) on the remote control if learning was unsuccessful. In this case, start over from step 4.

	DTV/CBL	MD/TAPE	TUNER	XM	TV	POWER
	DVR	DVD	CD	NET/USB	AV	POWER
	VCR	BD/HD DVD	CD-R	AUDIO SEL		STANDBY
SELECT	V-AUX/DOCK	PHONO	MULTI CH IN	SLEEP		POWER

Other remote control

y

•If you want to program another function, repeat steps 4 and 5.

•If you continuously want to program another function for another component, press BSELECT k / n to select the component, and then repeat steps 4 and 5.

6Press MLEARN again to exit the learning mode.

LEARN

Notes

•“ERROR” appears in the display window (B) on the remote control if you press a button not indicated in the respective step, or when you press more than one button simultaneously.

•This remote control can learn approximately 200 functions. However, depending on the signals learned, “FULL” may appear in the display before you program 200 functions. In this case, clear unnecessary programmed functions to make room for further learning.

•Learning may not be possible in the following cases:

–when the batteries in the remote control for this unit or other components are weak.

–when the distance between the two remote controls is too great or too small.

–when the remote control infrared windows are not facing each other at the appropriate angle.

–when the remote control is exposed to direct sunlight.

–when the function to be programmed is continuous or

uncommon.

Changing source names in the display window

You can change the name of the input source that appears in the display window (B) on the remote control if you want to use a different name from the factory preset. This feature is useful when you have set an input area to control a different component.

1Set the operation mode selector to DAMP or DSOURCE and then press an input selector button (1) to select the input area you want

to rename.

The name of the selected input area appears in the display window (B).

AMP
SOURCE
	XM	NET/USB
TV
or	TUNER	CD	CD-R	MULTI CH IN
AMP	MD/TAPE	DVD	BD/HD DVD	PHONO
SOURCE
	DTV/CBL	DVR	VCR	V-AUX/DOCK

TV

2Press MRENAME using a ballpoint pen or similar object.

RENAME

Note

If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, start over from step 2.

110 En