Yamaha RX-V3800 owner manual Manual Setup Video, 89 En, Conversion Video conversion, control

Manual Setup (Video)

Use this menu to adjust the video parameters.

1Set the operation mode selector to DAMP and then press GSET MENU on the remote

control.

2Press 4k / n / l/ h on the remote control to select “Manual Setup” and then press 4h.

3Press 4k / n / l/ h on the remote control to select “Video” and then press 4h.

4Select the desired parameters and then press 4h to access and adjust.

Note

Use the “Video” in “Initialize” to set the parameters in “Manual Setup (Video)” (except “Short Message” and “On Screen”) to the factory presets (see page 126).

■Conversion (Video conversion)

Use this feature to activate or deactivate the video scaling as well as the HDMI up-conversion of the analog video signals input at the composite VIDEO, S VIDEO, and COMPONENT VIDEO jacks.

Choice	Functions
On	Converts composite, S-video, and component
	video signals interchangeably and up-converts
	composite, S-video, and component video
	signals to HDMI video signals.
Off	Does not convert any signals.

Graphical user interface (GUI) screen

Notes

•This unit does not convert 480 line video signals and 576 line video signals interchangeably.

•The analog component video signals with 480i (NTSC)/576i (PAL) of resolution are converted into the S-video or composite video signals and output at the S VIDEO MONITOR OUT and VIDEO MONITOR OUT jacks.

•The converted video signals are only output at the MONITOR OUT jacks. When recording a video source, you must make the same type of video connections between each component.

•When composite video or S-video signals from a VCR are converted into component video signals, the picture quality may suffer depending on your VCR.

•Even when “Conversion” is set to “On”, HDMI digital signals are not converted to analog video signals.

•If “Conversion” is set to “Off”, the “Component I/P”, “HDMI Resolution”, “HDMI Aspect”, and “Short Message” features are deactivated.

•Set “Conversion” to “On” to display the short message.

•Unconventional signals input at the composite video or S-video jacks cannot be converted or may be output abnormally. In such cases, set “Conversion” to “Off”.

•When non-standard video signals (such as video signals from a video game console) are input, this unit does not display short messages on the video monitor even if “Conversion” is set to “On”.

•When the analog component video signals with 480p of resolution are input at the COMPONENT VIDEO jacks and the video monitor is connected to the VIDEO MONITOR OUT or S VIDEO MONITOR OUT jack of this unit, the GUI screen is not displayed on the video monitor.

•This unit does not up-scale the analog component video signals with 720p or 1080i of resolution.

■Component I/P (Component interlace/

progressive conversion)

Use this feature to activate or deactivate the analog interlace/progressive conversion of the analog video signals input at the composite video, S-video and component video jacks so that the analog video signals deinterlaced from 480i (NTSC)/576i (PAL) to 480p/576p are output at the COMPONENT MONITOR OUT jacks.

Choice	Functions
On	Activates the analog interlace/progressive up-
	conversion of the analog video signals.
Off	Deactivates the analog interlace/progressive up-
	conversion of the analog video signals.

OPERATION ADVANCED

Notes

•This menu item is not available and hence not visible in the GUI screen if “Conversion” is set to “Off”.

•If your video monitor does not support analog video signals with 480p/576p of resolution, the GUI screen may not be displayed on your video monitor when “Component I/P” is set to “On”. In such a case, set “VIDEO” of “INITIALIZE” in “ADVANCED SETUP” parameter to “Off” (see page 126).

English

89 En