Yamaha RX-V3800 123 En, Wake on RS-232C access, Remote control AMP ID, Csource, Press 4ENTER

■Wake on RS-232C access

RS-232C STANDBY

Use this feature to set this unit to transmit data via the RS- 232C interface when this unit is in the standby mode. Choices: YES, NO

Initial setting:

[U.S.A. and Canada models]: YES

[Other models]: NO

•Select “YES” to set this unit to transmit data via the RS-232C interface.

•Select “NO” to set this unit not to transmit data via the RS-232C interface.

■Remote control AMP ID

RC AMP ID

Use this feature to set the AMP ID of this unit for remote control recognition.

Choices: ID1, ID2

•Select “ID1” when the remote control AMP ID library code is set to “2001”.

•Select “ID2” when the remote control AMP ID library code is set to “2002”.

Setting remote control AMP ID code

1Set the operation mode selector to CAMP or

CSOURCE.

2Press and hold MLEARN for about 3 seconds using a ballpoint pen or similar object and then press 4l / h repeatedly until “L;AMP” appears in the display window (B) on the remote control.

PRESET/CH

LEARN

ENTER

A-E/CAT.

Advanced setup

3Press 4ENTER.

The four-digit code set for the selected input area appears in the display window (B) on the remote control.

4Press the numeric buttons (6) to enter the four-digit remote control AMP ID code for the input area you want to use.

Remote
control AMP	Function	RC AMP ID*2
ID code*1
2001	Operates this unit using the	ID1
(initial setting)	default code.	(initial setting)
2002	Operates this unit using an	ID2
	alternative code.

*1 The remote control setting.

*2 The setting of this unit.

5Press 4ENTER to set the number.

“OK” appears in the display window (B) if the setting was successful.

“NG” appears in the display window (B) if the setting was unsuccessful. In this case, start over from step 2.

PRESET/CH

ENTER

A-E/CAT.

6Press MLEARN again to exit from the setup mode.

LEARN

OPERATION ADVANCED

Notes

•Be sure to press and hold MLEARN for at least 3 seconds, otherwise the learning process will start.

•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 2.

English

123 En