Yamaha RX-V3800 owner manual Getting started, 5 En, Installing batteries in the remote control

Getting started

■Installing batteries in the remote control

2 1

3

1Press the part and slide the battery compartment cover off.

2Insert the four supplied batteries (AAA, LR03) according to the polarity markings (+ and –) on the inside of the battery compartment.

3Slide the cover back until it snaps into place.

■Installing batteries in the Zone 2/Zone 3 remote control

13

2

Notes

•Change all of the batteries if you notice the following conditions:

–the operation range of the remote control decreases.

–the transmit indicator (P) does not flash or its light becomes dim.

•Do not use old batteries together with new ones.

•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

•We strongly recommend that you use alkaline batteries.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

•Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations.

•If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries, set up the remote control code and program any acquired functions that may have been cleared.

■VOLTAGE SELECTOR

(Asia and General models only)

Caution

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.

Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver.

Voltages are as follows:

.......................AC 110/120/220/230–240 V, 50/60 Hz

INTRODUCTION

1Take off the battery compartment cover.

2Insert the two supplied batteries (AAA, LR03) according to the polarity markings

(+ and –) on the inside of the battery compartment.

3Snap the battery compartment cover back into place.

VOLTAGE

SELECTOR

230-

240V

Voltage indication

English

5 En