Yamaha RX-V3800 owner manual 108 En, Set the operation mode selector to, Press 4ENTER

Remote control features

1Set the operation mode selector to

DSOURCE and then press an input selector button (1) to select the input area you want to set up.

2Press and hold MLEARN for about 3 seconds using a ballpoint pen or similar object.

The library name (ex. L;DVD) and the name of the selected input area (ex. DVD) appear alternately in the display window (B) on the remote control.

y

•You can set a remote control code of a different type of component to an input area. Press 4l / h repeatedly to change the library (component category).

Library choices: L;DVD, L;DVR, L;LD, L;CD, L;CDR, L;MD, L;TAP (tape), L;TUN (tuner), L;AMP, L;TV, L;CAB (cable), L;SAT (satellite), L;VCR

•If you want to setup for another input area, press the input selector button, or press BSELECT k / n repeatedly to select the input area.

Notes

•Be sure to press and hold MLEARN for at least 3 seconds, otherwise the learning process will start.

•If you do not complete each of the following steps within 30 seconds, the setting mode will be automatically canceled. In this case, start over from step 2.

3Press 4ENTER.

The four-digit code set for the selected component appears in the display window (B).

Note

“0000” appears in the display window (B) if no code has been set.

4Press the numeric buttons (6) to enter the four-digit remote control code for the component you want to use.

For a complete list of available remote control codes, refer to “List of remote control codes” at the end of this manual.

5Press 4ENTER to set the number.

“OK” appears in the display window (B) on the remote control if setting was successful.

“NG” appears in the display window (B) on the remote control if the setting was unsuccessful. In this case, start over from step 3.

y

If you continuously want to set up another code for another component, press the input selector button, or BSELECT k / n repeatedly to select the component, then repeat steps 2 through 5.

6Press MLEARN again to exit from the setup mode.

7Press 4p or AV POWER to confirm whether you can control your component using the remote control.

y

If operation is not possible and the manufacturer of your component has more than one code, try each of them until you find the correct one.

Notes

•“ERROR” appears in the display window (B) on the remote control if you press a button not indicated in the respective step, or when you press more than one button simultaneously.

•The supplied remote control does NOT contain ALL possible codes for commercially available audio and video components (including Yamaha components). If operation is not possible with any of the remote control codes, program the new remote control function using the learn feature (see “Programming codes from other remote controls” on page 109) or use the remote control supplied with the component.

•Functions programmed using the learn feature take priority over remote control code functions.

108 En